14
Recording Equipment
Press Init. Butt. On Equipment
Lets you program system devices into the control
panel memory.
1. Install batteries into all system devices* (refer to the
installation instructions). Make sure bases are attached
to devices to secure the tamper switches.
2. Press and release the program button on the desired
device using a paper clip end (see graphics on right side
of page for device program button locations). The
device LED starts ashing. Wait for the keypad display
to show “Device Type 1 Recorded”.
3. Press YES. The display shows RADIO RANGE TEST?
Press YES again. The device LED starts ashing and
the display shows TEST IN PROGRESS.
Note The Radio Range Test prompt does not appear
when programming keyfobs.
4. Take the device to its intended mounting location and
make sure the LED ashes once every second,
indicating good communication with the control panel.
5. Press YES to end the radio range test, then press
ESC/NO.
6. The display now shows AREA ALLOCATION: AREA:1.
Press either arrow button repeatedly until the desired
area number appears, then press YES.
Note The Area Allocation prompt does not appear
when programming keyfobs or sirens.
7. The display shows PROTECT AN EXTERNAL ACCESS?
Press YES or ESC/NO, whichever is appropriate for
this device.
Note The Protect An External Access prompt only
appears when programming door contacts.
8. The display shows NAME + LOCATION. Enter the
appropriate device name/location (up to 16 characters),
then press YES. The display shows the device number
and name for your verication.
Note The Name + Location prompt does not appear
when programming keyfobs or sirens.
9. Press YES. The display shows FUNCTIONAL TEST?
Press YES again and verify the device operation.
For example, waving your hand in front of a motion
detector should activate its LED indicating detection.
Moving a magnet away from a door contact should
activate its LED indicating detection.
10. Press YES to end functional test.
11. The display shows RECORDING NEW EQUIPMENTS?
Press YES to continue programming remaining devices.
Camera PIR Motion Detector
Door Contact Keyfob (Press and hold On
and Off buttons for 5 seconds,
then release.)
Sirens
Program Buttons
Initial Configuration/Programming
Installation Sequence
* All installation instructions, manuals are available at our web site www.videoed.com. Go to dealer support, click on “To Login”. User
name = “your rst name”, the Password = “videoed”. Then click on “Technical Documentation” you now have access to all RSI instal-
lation sheets and manuals
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji